^isaprocart^

Set of 6 Nuts and Screws to fit all the cleartides range of reactors

Quantity:
Buy Now:

Ideal for use with all Slow Feed Reactors.... auto feeders, nitrate N40 and N100 and similar.

Wiith this kit allows  you to use any existing pump supply... no need to buy an additional pump. This is done by the use of a Tee Piece (supplied) .. this allows you to 'cut' into the out going pipe of the pump... and has these reactors are drip fed, there will be no or little interference with the running of the existing pump ... so you can use your external, return or a power head to run.

Kit Consists of :

Control Valve 6mm , 6mm Piping (2 metres) and Tee Piece. When purchasing, please state size of Tee Piece required.

Tee Piece Sizes : 10mm, 12mm, 16mm, 20mm, 25mm and 40mm  .. this should be the diameter (inside diameter) of the out going pipework of the pump to be used.

Quantity:
Buy Now:

Ideal for use with all cleartides reactors with 13mm fittings.... Sand, PO4 and Dual reactors.

To be used inconjunction with an existing pump, without the need for the expense of a new supply pump.

with this kit, it allows you to use any existing pump supply... no need to buy an additional pump. This is done by the use of a Tee Piece (supplied) .. this allows you to 'cut' into the out going pipe of the pump... the flow from the existing pump supply should be around 1000lph+ in run the reactors correctly.

Kit Consists of :

Control Valve 13mm , 13mm Piping (2 metres) and Tee Piece.

When purchasing, please state size of Tee Piece required.

Tee Piece Sizes : 10mm, 12mm, 16mm, 20mm, 25mm and 40mm  ... the one required will equal the out going diameter of the pump you are going to use.

Quantity:
Buy Now:

Sponges to fit all 90mm bodied reactors.

Quantity:
Buy Now:

Replacement gasket for your reactor 150 - 300 range.

State on purchase which reactor the gasket is for .. otherwise the wrong one could be sent.

Quantity:
Buy Now: